475 Floor Deck Equipment: tile press equipment operation and precautions: Hand put blanks, take blank work program: Before the equipment used to check around the connection is solid, mounting bolts, whether tighten the nut should be added within about chassis Foot lubricating oil, to power-up test machine, first empty running carefully observed, with or without vibration, noise, oil window is to oil, whether coordinated movement of the components, you can install all the normal mold, mold installation, you must turn off the power by hand moving belt or large gear motor, so the table indexing, and rose to the highest point of the carriage, it is best to use an object supported between the table and the bottom surface of the slide to slip seat naturally fall, causing the accident . Mold needs a machine to use the same mold and six sizes of the lower die, install upper and a lower die, the die is mounted directly in the six-party table runner, mold is installed on the bottom surface of the carriage, and Place appropriate thickness plate, ensure mold clamping down after four evenly around the gap between the upper and lower mold distance equal to the thickness of the tiles you want. Then prevail over mold, table indexing, install the remaining five pay lower die, all in order to drive up and down mode after installing pressure-watts. Automatic discharge, whichever is blank work program: Mold installation and commissioning with these hosts, then open air compressors, vacuum pumps, extruders, Ceva machine, discharge machines, tile press, host and Salvatore conveyors, stopping , stop the extruder, then stop the rest of the device 475 Floor Deck equipment products are light weight, high strength, major, and good shock resistance, is widely used in the field of high-rise steel buildings.